Description

14:09 4-in-1 Security Dome Camera Press OSD joystick to switch the output mode: Default / Right for 5 seconds: CVBS 960H Down for 5 seconds: CVI Left for 5 seconds: AHD Up for 5 seconds: TVI 1080P 4-in-1 Security Bullet Camera Security Camera Specification This camera is recommended to work with a security DVR. This camera needs to be wired with bnc video cable and power cable. This item will not come with the cctv cable & power supply. Image Sensor: 1/3〞CMOS CMOS with IR-Cut. Lens: 3.6mm Active Pixels: 1920(H)×1080(V). Singal mode: CVBS 960H / TVI / AHD / CVI. IR LEDs Amount: 24pcs, 5mm LEDs. IR Distance(night vision): up to 80FT Made: Aluminum Metal Casing Power supply: 12V 500mA This 1080p full HD camera has a built-in OSD menu that can change the 4 different video outputs：HD-TVI, AHD, CVI, and CVBS(960H)， and adjust the video settings. Operation Mode： Switch from AHD: Press Leftward for 5 Seconds Switch from TVI: Press Rightward for 5 Seconds Switch from CVBS: Press Upward for 5 Seconds Switch from CVI: Press Downward for 5 Seconds Noted: Default Video Mode is Analog 960H Mode Advanced DWDR Technology DWDR (Digital Wide Dynamic Range) technology automatically adjust the picture's brightness to let you see and capture a lot more details in a wide range of light conditions - from bright highlights to dark shadows. 1080p HD & 90° Angle View With 2.0MP lens and 90° wide field of view, you can see everything clear and smooth in perfectly crisp 1080p HD with every subtle details. Get clearer and sharper images/videos than 720p cameras. Enhanced Clarity with 3D-DNR 3D-DNR (Digital Noise Reduction) technology filters out digital noise from low-light scenes, as well as any noise caused by motion. By eliminating graininess, you can see more fluent image in better clarity, sharpness and get improved motion detection. Troubleshooting Q: Video Loss appears where the image from my camera should be displaying on my DVR? A: 1.Check the extension cable (power and video) is securely connected to the camera. 2.Check the video output from the camera is securely connected to a video input channel on the DVR. 3.Check the power from the camera is securely connected to a power supply. 4. The camera mode do not match your DVR.there is 2 ways to setup . (1) Press OSD Joystick “DOWN” 5 seconds,if still no picture come, try to press “LEFT” “RIGHT””UP” for 5 second, till the signal matching your DVR. (2) Make sure the signal of your DVR, Use OSD Joystick to change the mode of the camera according to your DVRs video Mode.